Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
10.1. Features of a design
10.2. Diagnostics of malfunctions of electric equipment
10.3. Assembly blocks
10.3.1. Arrangement of safety locks and relay
10.3.2. Replacement of safety locks and the relay in assembly blocks
10.3.3. Removal and installation of the assembly block of salon
10.3.4. Removal and installation of the block of the relay and safety locks of headlights and conditioner
10.3.5. Removal and installation of the block of the relay and safety locks of electrofans of system of cooling
10.3.6. Removal and installation of the block of power safety locks
10.3.7. Replacement of additional safety locks and relay of system of injection of fuel
10.4. Storage battery
10.5. Generator
10.6. Starter
10.7. Switch (lock) of ignition
10.8. Electronic control system of the engine (ESUD)
10.9. Ignition system
10.10. Lighting, light and sound alarm system
10.11. Windscreen cleaner
10.12. Windscreen washer
10.13. Electrofans of system of cooling of the engine
10.14. Electric motor of the fan of system of heating (conditioning) and salon ventilation
10.15. Heating system of back glass
10.16. Removal and installation of the boss of the lighter
10.17. Combination of devices
10.18. Replacement of switches of the dashboard
10.19. Automobile audiosystem
10.20. Replacement of sensors and switches
11. Body
12. Appendices
13. Electric equipment schemes
 






8c4a8411
У Москві з явилися готелі для домашнього улюбленця




10-3-4-snyatie-i-ustanovka-bloka-rele-i-predokhranitelejj-far-i-kondicionera.html

10.3.4. Removal and installation of the block of the relay and safety locks of headlights and conditioner

It be required to you: a key «on 10», a pricker or a thin screw-driver with a flat edge.
1. Disconnect a wire from the minus plug of the storage battery.
2. Unscrew nuts of fastening of the block to an engine mudguard...
3.... also remove the block from hairpins.
4. Wring out clamps of the bottom cover of the block...
5.... also uncover.
6. A pricker or a thin screw-driver with a flat edge wring out clamps of plugs of electroconducting, take plugs with wires from the assembly block and remove the assembly block from the car.

Good advice
Mark plugs not to mix at installation of the new assembly block.

7. Establish the block of the relay and safety locks of headlights and the conditioner as it should be, the return to removal.

«previous page
10.3.3. Removal and installation of the assembly block of salon
following page»
10.3.5. Removal and installation of the block of the relay and safety locks of electrofans of system of cooling