|
10-3-2-zamena-predokhranitelejj-i-rele-v-montazhnykh-blokakh.html
10.3.2. Replacement of safety locks and the relay in assembly blocksIt be required to you: a screw-driver with a crosswise edge, пассатижи with narrow sponges.
|
|
|
|
1. For receiving access to safety locks and the relay of the assembly block located in salon, turn out four screws of fastening of the ware shelf...
|
2.... also remove the shelf.
|
3. Before replacing fused safety lock, find out the reason of its peregoraniye and eliminate it. When troubleshooting see the chains specified in tab. 10.1 which are protected by this safety lock.
|
Prevention
Do not replace safety locks with crossing points or the safety locks calculated on other current, and self-made crossing points is can lead to damage of electric devices and even to a fire.
|
|
|
|
|
4. Hook tweezers on a safety lock and take it from the contact socket.
|
5. The fused safety lock (the crossing point shown by an arrow in the holder fused and it was opened) so looks. For replacement of a safety lock use a spare safety lock of the same face value.
|
6. Establish in the contact socket a safety lock of the same face value, as removed.
|
|
|
|
7. For receiving access to safety locks and the relay of headlights and the conditioner compress clamps...
|
8.... also uncover the assembly block.
|
9. Hook tweezers on a safety lock and take it from the contact socket.
10. Establish in the contact socket a safety lock of the same face value, as removed.
|
|
|
|
11. In need of replacement take the relay from the assembly block, shaking it here and there, and establish the new relay.
|
12. For receiving access to safety locks and the relay of electrofans of system of cooling compress clamps...
|
|
|
|
|
13.... also uncover the assembly block.
|
14. Take a replaced safety lock, using for this purpose, for example, пассатижи with narrow sponges.
|
15. Establish in the contact socket a safety lock of the same face value, as removed.
|
|
|
|
16. In need of replacement take the relay from the assembly block, shaking it here and there, and establish the new relay.
|
17. For receiving access to power safety locks compress clamps...
|
|
|
|
|
18.... also uncover the block of safety locks.
|
19. Take a safety lock from the block, using for this purpose пассатижи with narrow sponges.
|
20. Establish in the block socket a safety lock of the same face value, as removed.
|
|
