Chery Amulet since 2006
	1. Car device
	2. Recommendations about operation
	3. Malfunctions in a way
	4. Maintenance
	5. Engine
		5.1. Features of a design
		5.2. Possible malfunctions of the engine, their reason and ways of elimination
		5.3. Compression check in cylinders
		5.4. Removal and installation of protection of a case of the engine
		5.5. Replacement of support of a suspension bracket of the power unit
		5.6. Installation of the piston of the first cylinder in the provision VMT of a step of compression
		5.7. Removal, defektovka and flywheel installation
		5.8. Replacement of details of consolidation of the engine
		5.9. Head of the block of cylinders
		5.10. Removal and engine installation
		5.11. Engine repair
		5.12. Greasing system
		5.13. Cooling system
			5.13.1. Features of a design
			5.13.2. Possible malfunctions of system of cooling, their reason and ways of elimination
			5.13.3. Removal and installation of electrofans of a radiator of system of cooling
			5.13.4. Replacement of a radiator of system of cooling
			5.13.5. Replacement of the water pump
			5.13.6. Removal and thermostat installation
			5.13.7. Removal and installation of a broad tank
		5.14. Power supply system
		5.15. Catching system паров fuels
		5.16. Cистема of production of the fulfilled gases
	6. Transmission
	7. Running gear
	8. Steering
	9. Brake system
	10. Electric equipment
	11. Body
	12. Appendices
	13. Electric equipment schemes

5-13-3-snyatie-i-ustanovka-ehlektroventilyatorov-radiatora-sistemy-okhlazhdeniya.html

5.13.3. Removal and installation of electrofans of a radiator of system of cooling

It be required to you: a key and a face head «on 10», a screw-driver with a flat edge.

1. Disconnect a wire from the minus plug of the storage battery.


2. Wring out clamps of blocks of plaits of wires of electrofans...	3.... also separate blocks.


4. Turn out on two bolts of fastening of a casing of electrofans to a radiator at the left...	5.... in an average part...


6.... and on the right...	7.... and then remove electrofans assembled with a casing.

8. Establish electrofans as it should be, the return to removal.