Chery Amulet since 2006
1. Car device
2. Recommendations about operation
3. Malfunctions in a way
4. Maintenance
5. Engine
6. Transmission
7. Running gear
8. Steering
9. Brake system
10. Electric equipment
11. Body
11.1. Features of a design
11.2. Possible malfunctions of a body, their reason and ways of elimination
11.3. Removal and installation of facing of a radiator
11.4. Removal, dismantling and installation of bumpers
11.5. Removal and installation of mudguards of wheels and podkrylok
11.6. Removal and installation of a forward wing
11.7. Removal and installation of a lattice and facing of a box of airinflow
11.8. Cowl
11.9. Lateral doors
11.10. Back door
11.11. Removal and installation of a cover of the hatch of a bulk pipe of a fuel tank
11.12. Seats
11.13. Removal and installation of facing of a tunnel of a floor
11.14. System of passive safety (SRS)
11.15. Removal and installation of external rear-view mirrors
11.16. Removal and installation of casings of a steering column
11.17. Dashboard
11.18. Heater and conditioner
11.19. Salon fittings
11.20. Screen wiper of a wind window
11.21. Replacement of a motionless glazing of a body
11.22. Care of a body
12. Appendices
13. Electric equipment schemes
 






8c4a8411




11-3-snyatie-i-ustanovka-oblicovki-radiatora.html

11.3. Removal and installation of facing of a radiator

It be required to you: a key «on 10», a screw-driver with a flat edge.
1. Turn out four bolts of fastening of facing to the forward panel.
2. Hook a screw-driver the left lower part of decorative facing of a radiator and deduce clamps from holders on a bumper, similarly disconnect clamps on the right side.

Good advice
In order to avoid damage of a paint and varnish covering wind a screw-driver edge with an insulating tape and enclose under it a rags or rubber slice.

3. Remove radiator facing.
4. Establish facing upside-down.

«previous page
11.2. Possible malfunctions of a body, their reason and ways of elimination
following page»
11.4. Removal, dismantling and installation of bumpers